eDynamo Pairing

Hold the power button down for 3 seconds until the blue light flashes

Go to “Operation”

Enter 000000 and select pair

Select “Hardware Settings”

Select the eDynamo that you are connecting and after selecting a “Check Mark” will appear

• Related Articles

• PAX s300 IP Address Help

  How to find the IP Address:   Log into the PAX Terminal (Hold Function + 1 to open the menu, enter the PW)   Navigate to communication Click LAN Parameters Click IP Address Set the IP Address by typing it into the system (Example Below) How to set ...

• Verify Credit Card Tip

  *NOTE* YOU MUST SUBMIT BATCH BEFORE VIEWING REPORT FOR SAME DAY Navigate to Settings, and then Reports Run the report: The report will show like this: Verify that the tip applied in the system matches the written tip on the credit card receipt:

• Bluetooth Scanner

  Connecting a BT Scanner: Turn on the Scanner by holding down the small black button until you see the green and blue lights After device is on scan this barcode. This will reset the scanner back to factory default The device will now turn off and you ...

• Scale Setup Via Epson Printer Guide

  Attached below is a guide to our Epson printer scale setup.

• Enhancement in Gift Card

  Implementation in Back Office:   Page Navigation: My Stores >> Products/Items >> Gift Card   Users can do issue (sold), recharge, Adjust for the gift card at the back office.   And the values are recorded in the gift card report as well as in the ...