Inventory Yield CR

Inventory Yield CR

Introduction

This document explains – Inventory Yield Percentage CR

Requirement

When there is change in the yield % (when yield percentage is below 100% then the price per unit will not change and the quantity will be 1 instead of taking from the next quantity), the price per unit will not change.

Implementation in Back Office

Page Navigation: My Store >> Inventory >> Inventory Item

When a user creates any inventory item with 100% yield and the price per unit will reflect based on the Price field.

Price Per Unit = Price/Quantity

When a user creates any inventory item with 80% yield, then the price per unit will reflect based on the Price field. For example, there will be 20% wastage and there is no impact in the Price per unit and quantity.

Inventory Unit

Inventory Item

Price

Quantity

Yield %

Price Per Unit

Tomato

10

1

100

10

100

5

100

20

When there is change in yield% (Existing Flow)

Inventory Item

Price

Quantity

Yield %

Price Per Unit

Tomato

10

1.2

80

12.5

100

5.5

80

22.5

 

When there is change in yield% (New Flow)

Inventory Item

Price

Quantity

Yield %

Price Per Unit

Tomato

10

1

80

10

100

5

80

20

 

The Price Per Unit and Quantity should be the same (when the yield percentage changes, there should not be any changes in the quantity and as well as in the price per unit).

When any purchase is made, the yield % will not be considered here. The Price Per Unit will be based on the Total Price and Quantity (Price Per Unit = Price/Quantity).

When there is change in the yield %, the impacted areas are Master Stock Report, Wastage Report (it shows that remaining 20% waste in wastage report), Consumption Log, Count Sheet, Compare Inventory (existing flow).

Note: The same will be applicable for Sub-Recipe, Central Warehouse, Central Kitchen.

When any inventory item is created and if purchase is not made and if user make any consumption then the quantity will show as Negative. In this scenario, when any purchase is made with the particular vendor then the yield percentage will be based on that vendor only and wastage will be calculated based on current yield percentage only.

    • Related Articles

    • Inventory Items

      Creating an Inventory Item: ​ “Inventory”, “Inventory Items”, “+Inventory Item” Note: When setting up an inventory item, you must have Ingredient Categories, Storage Locations, Vendors, and In House Units created Select a Category for the item Select ...
    • Adjust Inventory Reasons

      Creating an Adjust Inventory Reason: ​ Select “Inventory”, “Adjust Inventory Reasons”, “+Reason” Type in the name of the reason and select if the reason will be an increase or decrease
    • Build Version 2.1.22 - Inventory Release

      Back office: Inventory Enhancements: Inventory Phase 2: Inventory subcategory is included as like in Products/Items. Subcategory filter option is included in Inventory reports. Default filter option “Adjust Inventory” is added in Adjust Inventory ...
    • Adjust Inventory

      Adjusting Inventory by Item: ​ Select “Inventory”, “Adjust Inventory”, then select the green button next to the item you want to adjust Select a Reason Type You will be able to change the count Bulk Update to Inventory: Select “Inventory”, “Adjust ...
    • Inventory Modifiers

      Linking Modifiers to Inventory: ​ Select the arrow under “Controls” to open the modifier settings Select an Item Type Select Category Select Item “Check mark” will indicate modifier is linked with inventory