S700 Scanner Setup

S700 Scanner Setup



Go into Bluetooth first and press the i with a blue circle and forget the socket s700 scanner before you proceed. See attached document for further information.

 

1. Then turn on the scanner and scan Step 1: this will make a sound and turn the scanner off

2. Turn the scanner back on and wait until you see the blue Bluetooth light flashing

3.  Scan Step 2 and it should make a beep sound

4. scan step 3 sometimes when you hold the button down you need to slowly pull away from the scanner for it to read it and it should make a beep sound.

5. On the last page scan the barcode for Scanner Always On

6. On the iPad go to Bluetooth under another device you will see the scanner touch it and it should show up in my devices as connected.

7. Force close the pos app and start it again it should now it should work

8. This setup takes care of most Standard bar codes.








    • Related Articles

    • Bluetooth Scanner

      Connecting a BT Scanner: Turn on the Scanner by holding down the small black button until you see the green and blue lights After device is on scan this barcode. This will reset the scanner back to factory default The device will now turn off and you ...

    • S700 & S740 Scanner Instructions

      Print this document on a good quality printer. Go into Bluetooth first and press the I with a blue circle and forget the socket s700 scanner before you proceed. 1.Then turn on scanner and scan Step 1: this will make a sound and turn the scanner off ...

    • Face ID Setup

      Face ID is a module that requires Licensing. Once you add to your store subscription on Bon under the License setting, you can turn it on. If this is an Enterprise account, you will need to purchase for each store that you need Face ID available and ...

    • Scale Setup Via Epson Printer Guide

      Attached below is a guide to our Epson printer scale setup.

    • Caller ID Setup

      Blue print of the caller-id Setup:                               Three LAN Ports at back of caller Id box: Power adapter (Should connect to Power cord) To Data Network port (Should Directly connect to Network) Towards Gateway (Should Directly connect ...